Beko Plasma TV Manuel de service télécharger pdf (Page 116)

Beko Elektronik A.S Service Manual Plasma Display Module-Samsung V3

39 / 44

( Photo 2 )

1) Remove the screws in order of 2-3-5-7-1-4 from heat sink and then get rid of heat sink. ( Photo 1 )

2) Remove the TPC, FFC and power cable from the connectors.

3) Remove all of the screws from defected board.

4) Remove the defected board.

5) Replace the new board and then screw tightly.

6) Get rid of the foreign material from the connector.

7) Connect the TCP,FFC and power cable to the connector.

8) Reassemble the TCP heat sink.

9) Screw in order of 4-1-7-6-5-3-2. ( Photo 2 )

If you screw too tightly, it is possible to get damage on the Driver IC of TCP.

* Logic

5-3-5 Exchange YBU, YBL and YM board

1) Separate all of the FPC connector of YBU (Y-Buffer upper) and YBL (Lower). ( Photo 1 )

2) Separate all of the connector of CN5001 and CN5008 from Y-Main.

3) Loosen all of the screws of YBU, YBL and YM.

4) Remove the board from chassis.

5) Remove the connector of CN5006 and CN5007 among YBU, YBL and YM.

6) Remove the YBL and YBU from Y-main.

7) Replace the defected board.

1 2 ... 111 112 113 114 115 116 117 118 119 120 121

Pas de commentaire

Beko Plasma TV Manuel de service Page 116