Ending the programe through
canceling
The programme which is selected first will
keep on going even if the position of the
programme selection button is changed.
A new programme can be selected and
started after “Programme cancel” is
activated in order to change the drying
programme.
To cancel any selected programme;
• Press “Start/Pause/Cancel” button for
about a duration of 3 seconds. The “Filter
cleaning”, “Water tank” and “End/ Anti-
creasing” warning LEDs will light up at the
end of this period for reminding purposes.
A As the inside of the machine will be
excessively hot when you cancel the
programme while the machine is running,
activate the ventilation programme to cool
it down.
A If the machine is stopped during any
drying programme, and if the position
of the programme selection knob is
changed, an audio signal will be heard
(if the “Cancel audio warning” function
is not selected).
The machine will not start even if the
“Start/Pause/Cancel” button is
pressed, unless the programme
selection knob is returned to the initial
programme. The paused programme
must be cancelled in order to change
the drying programme.
Adding/removing laundry in standby
mode
In order to add or take out laundry after the
start-up of the programme;
1. Press the “Start/Pause/Cancel” button
to switch the machine to “Pause” mode.
Drying process will stop.
2. Open the door at Pause position and
close it again after adding or taking out
laundry.
3. Press “Start/Pause/Cancel” button to start
the programme.
C Any laundry added after the drying
process was started may cause the
already dried clothes in the machine
intermingle with wet clothes and the
result will be wet laundry after the drying
process is over.
C Laundry may be added or taken out
as much as desired during a drying
process, but as this process will interrupt
drying continuously, it will extend the
programme duration and increase
energy consumption. Therefore, it is
recommended to add laundry before the
drying programme is started.
Child-proof lock
There is a childproof lock to prevent any
programme interruption due to the
pressing of keys while the programme
is on. The loading door and all keys
except the “On/Off” key on the panel are
deactivated when the child-proof lock is
active.
In order to activate the childproof lock,
press on the “Start/Pause/Cancel” and
“Cancel audio
warning” buttons
simultaneously for 3
seconds.
To start a new
programme after
the programme is
over or to interrupt
the programme, the childproof lock should
be deactivated. To deactivate the childproof
lock, press the same buttons for 3 sec.
C 2 beeps when activating and 1 beep
when deactivating the child-proof lock is
heard.
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels